INSTALLATION AND OPERATING INSTRUCTIONSBERRINGTONSOLID FUEL BOILER STOVEThis appliance is hot while in operation and retains its heat for a long perio
IMPORTANT NOTESNow that your Solid Fuel Stove is installed and no doubt you are looking forward to many comforts it will provide, we would like to giv
LIGHTING1. Before lighting the stove, ensure that any build up of ashes in the fire box has been removed and that the ashpan has been emptied.2. Ope
11Fig.12DISPOSAL OF ASHESThe stove is provided with a steel ashpan. This ash-pan must be emptied every day.If ashes are allowed to build up to grate
Fig.153. Use only products recommended by the Vitreous Enamel Association, these products carry the Vitramel label.4. DO NOT USE ABRASIVE PADS OR OVEN
BERRINGTON SOLID FUEL BOILER STOVE EXPLODED VIEW 131. RH Side2. Leg3. LH Side4. Front Frame5. Base Panel 6. Hob7. Ashtray Front8. Boiler9. Shaker Bar
TABLE OF CONTENTSPAGE NO.1. General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BERRINGTON SOLID FUEL STOVE INSTALLATION & OPERATING INSTRUCTIONSGENERALWhen installing, operating and maintaining yourBerrington Stove respect ba
Fig.42300600Soot DoorApplianceFLUE PIPESA flue pipe should only be used to connect an appli-ance to a chimney and should not pass through anyroof spac
4REAR FLUE EXITFor the rear flue outlet configuration, push in the flueconnector pipe (not supplied) into the flue outletsocket at the rear of the sto
5FLOOR PROTECTIONIt is recommended that this appliance is installed ona solid, level, non combustible hearth conforming tocurrent Building Regulations
6Fig 8NOTE: Dimensions stated below may be subject to a slight +/- variation.SPECIFICATIONSPECIFICATIONSMetricDepth 495mmFlue Outlet 152mmFire Door Si
PLUMBING REGULATIONSThe plumbing must be in accordance with all relevant regulations and practices. It must include agravity circuit with expansion p
8(closed to maximum). Setting 4 will provide themost heat from the appliance. The zero positionmay not always be in the 12 o’clock position but thek
Comments to this Manuals